Page 1: Operating Instructions. Drayton TO ALTER THE SET TEMPERATURE The SET temperature should be adjusted to a Digistat level at which you are comfortable, (try the preset 20°C to start and adjust if necessary). Depressing either the + or – button will activate SET mode and SET room temperature Digital room will be displayed. Drayton. Digistat RF 1 Wireless System User instructions SCR RECEIVER INITIAL START UP IMPORTANT: ENSURE THAT THE COMMISSIONING PROCEDURE HAS BEEN CARRIED OUT IN ACCORDANCE WITH THE ENCLOSED INSTRUCTIONS. SCR (RECEIVER) NORMAL OPERATING MODE Once the Wireless System has been commissioned, there should be little need for any user 5/5(1). MANUAL OVERRIDE The heating can be manually switched on and off by using the ‘OVERRIDE’ button on the SCR in a fault situation, even though the red LED will stay on until a satisfactory signal is reinstated. Once the SCR receives a satisfactory signal again, it will automatically reset itself for normal operation. Digistat RF 1 ‘Wireless System’.
COMMISSIONING THE DRAYTON DIGISTAT RF WIRELESS SYSTEM 1. Pop the Digistat unit off the wall and take over to SCR unit 2. Pull down battery drawers in Digistat unit and allow screen to go blank 3. Turn off the power supply to the SCR receiver unit and leave for 5 seconds 4. Turn on power to SCR unit and check red light is on 5. DIGISTAT RF1 Once the wireless system has been commissioned the unit will display the actual room temperature. The SET temperature comes preset at 20C, if the actual room temperature is below 20C, a flame symbol will appear at the left hand side of the display, this indicates a demand for heat (system will switch on). Digistat +1RF Digistat +1RF Digistat +1RF Digistat +1 Digistat + 1RF Digistat +1 + Technical Helpline Tel: Website: www.doorway.ru Email: www.doorway.ru@www.doorway.ru Drayton Controls reserve the right to make changes without notice and cannot accept liability for errors. Drayton Controls reserve the right.
Can anyone help? I have just moved into a house with a Drayton Digistat RF2 wireless system and Im trying to get hold of an instruction manual. QUICK RF COMMISSIONING GUIDE. Drayton Digistat + RF Wireless System. WARNING. If you do not have the knowledge to install the SCR safely then you must. their life (see 'battery replacement'). Red LED continually on. This denotes that the SCR has been unable to receive a radio signal from the.
0コメント